LEAD ENCAPSULANTS

L-B-C Lead Barrier Compound / Encapsulant 5801

Features:

• L-B-C is a high-solids, elastomeric-thermoplastic, water-based copolymer that meets or exceeds all projected federal, state and local standards for lead-based paint encapsulants. Blended specifically to form a durable and flexible encapsulant barrier between lead-based pain and the environment, L-B-C has been independently tested to the ASTM E-1795 requirements for Category III (Type III- Interior/Exterior) encapsulants. E-1795 is the principle performance standard required, adopted and/or incorporated by reference into lead paint abatement rules and regulations at the federal, state and local levels.  L-B-C has been certified by Massachusetts (No. DL-12362), authorized by the states of Connecticut, Ohio, New York, Maryland, Minnesota, and Colorado. L-B-C is accepted for use in all 50 states. L-B-C has also been classified by Underwriters Laboratories (UL®). L-B-C is environmentally friendly and complies with all federal and state VOC requirements.

  L-B-C contains Bitrex®, a bitter tasting, non toxic, anti-ingestant to discourage oral contact with lead paint. The required minimum 7 mil dry film thickness of L-B-C offers unparalleled interior and exterior coverage and economics. In addition, the lower film thickness reduces stress on the existing paint system and maintains architectural detail.

  L-B-C can be successfully applied to the proper thickness in one application with most major brands or airless spray equipment. L-B-C can also be applied by brush or roller. L-B-C Type III can be used for application with surface temperatures as low as 38 °F..

  Percent Solids:  62 ±2% by weight  Volatile Principally water

  Average Particle Size: 0.2 microns

  Weight: at 78°F 11.5 ±0.3 lbs/gal

  Viscosity: at 78°F 105 - 130 KU

  Flash Point: Noncombustible (Water-based)

  Minimum Shelf Life at 78°F 36 months

  Finish: Eggshell60° spec. gloss: 4 ±1 85° spec. gloss: 3 ±1

  Drying time: at 78°F To touch: 1-2 hours Additional coats/topcoat: 8-16 hours Full cure: 30 days

Fiberlock LEAD SHIELD Post Removal Lockdown

Lead Shield is a water based 100% acrylic lockdown with a dual purpose; it binds residual lead-based paint and dust present after removal; and accepts most topical coverings. The clear version of this product sprays on white and dries clear to permit visual inspection of any residual paint. The translucent blue tint speeds up the post removal inspection process after the product has fully cured. The blue tint is advantageous because it enables an inspector to quickly identify areas that LBP has been removed from and subsequently locked down. These unique features assist in obtaining final LBP removal certification. Lead Shield is a one step product which bonds to most surfaces eliminating the need for sanding, priming and sizing recently stripped walls. Lead Shield can be used on both interior and exterior surfaces, and was expressly formulated to prepare these surfaces to accept a final topical covering. Lead Shield should not be used as a substitute for encapsulation.